Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Vinyl Asylum ] [ Return to Search Results ]

---

[ Alert Moderator ]

---

RE: Low-budget SME 3009 II replacement bias weight...

Posted by 13D3Tube (A) on November 17, 2009 at 01:15:26

In Reply to: RE: Low-budget SME 3009 II replacement bias weight... posted by wpod on March 25, 2008 at 10:32:45:

3.5gm tungsten RIVER2SEA WORM WEIGHT SINKERS could be an excellent replacement for any bias weight. They will be smaller than the original, as the metal is 1,8 times heavier than lead, for the same size. However, the finish is matte, which may, or may not please.

I am wondering about adding a bias to an arm (actually two arms) that does not have one. I was going to add an SME bias guide, and use one of these wieghts. Is there any reason, apart from the precise graduations on the SME bias rod, for not tying the bias line directly onto the arm near to the rear weight? I want a very small amount of bias.
13D3

This post is made possible by the generous support of people like you and our sponsors:

Signature Sound

[ Signature Sound Lounge ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---