Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
Greetings- When I purchased this deck a couple of months ago, the onboard preamp was bypassed and the 929 tonearm is wired directly to the outputs. I'd like to return the table to it's original configuration to evaluate the preamp, but might need help locating where the six disconnected wires attach to. These six (red,brown, green, yellow, and two slightly shorter- orange and blue)wires come out of a white rectangular connector that plugs into the back of the main circuit board approximately 3 1/2 inches (88mm) from far right of the circuit board viewing the table from the front.I am pointing to that connector with a ball point pen in the above picure.I asked this same question over on vinylengine but wasn't able to upload this picture, so figured I'd try it here.Thanks for your help, wpod
This post is made possible by the generous support of people like you and our sponsors:
Topic - EMT 948- help needed reconnecting onboard preamp - wpod 06:53:04 03/27/08 (1)
- RE: EMT 948- help needed reconnecting onboard preamp - r17 09:34:45 03/27/08 (0)