Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: Can I Use A Y Splitter On My Phono Pre posted by tubav on December 22, 2020 at 08:01:51:
If you can look inside the chassis's of your amplifiers, you should see a resistor connecting the hot input to ground. Or look for it at the grid (if tubes) or gate (if SS) of the first active device. That resistor usually dominates the calculation of input impedance, and you can use that value as an estimate. There ARE exceptions to this rule of thumb.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Can I Use A Y Splitter On My Phono Pre - Lew 12/22/2009:54:42 12/22/20 (0)