Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
Highly resistant to flex and compression. Slightly electrically conductive.I'd want to try and use it with a ruby or silicon nitride ball.
~ 10 lbs or so worth of platter riding on top.
I could get this stuff machined into little discs....
About half way down that page is a link to the material data. "iglide® F2 - material data" On the page the link takes you to, you can click on the "technical data" tab to see the mechanical data.
This post is made possible by the generous support of people like you and our sponsors:
Topic - How about this for a thrust pad material? - Ugly 15:02:56 09/9/17 (22)
- RE: How about this for a thrust pad material? - WntrMute2 17:40:02 09/11/17 (3)
- RE: How about this for a thrust pad material? - Ugly 06:18:29 09/12/17 (2)
- RE: How about this for a thrust pad material? - WntrMute2 07:30:14 09/12/17 (1)
- RE: How about this for a thrust pad material? - Bryan Cheng 19:18:53 09/13/17 (0)
- RE: How about this for a thrust pad material? - mosin 16:23:02 09/10/17 (1)
- RE: How about this for a thrust pad material? - Ugly 21:43:22 09/10/17 (0)
- RE: How about this for a thrust pad material? - mr.bear 21:13:33 09/9/17 (15)
- RE: How about this for a thrust pad material? - Ugly 07:42:16 09/10/17 (3)
- RE: How about this for a thrust pad material? - mr.bear 12:01:28 09/10/17 (2)
- Are any of these materials better for the accidental shock impulse loads? - Ugly 18:51:48 09/11/17 (0)
- RE: How about this for a thrust pad material? - Ugly 13:56:11 09/10/17 (0)
- RE: How about this for a thrust pad material? - Tre' 07:26:44 09/10/17 (10)
- RE: How about this for a thrust pad material? - mr.bear 11:03:22 09/10/17 (8)
- RE: How about this for a thrust pad material? - Penguin 22:43:33 09/10/17 (0)
- RE: How about this for a thrust pad material? - Tre' 16:37:52 09/10/17 (6)
- OK, 16.5mm will fit but now.... - Tre' 18:58:36 09/10/17 (5)
- This is the advice I got to remove the ball - Barry 19:13:12 09/11/17 (1)
- RE: This is the advice I got to remove the ball - Tre' 20:29:51 09/11/17 (0)
- RE: OK, 16.5mm will fit but now.... - Not Yet There 10:55:48 09/11/17 (1)
- Got it, thanks - Tre' 11:06:56 09/11/17 (0)
- Should sound terrific and... - Barry 07:11:31 09/11/17 (0)
- RE: How about this for a thrust pad material? - Ugly 07:54:22 09/10/17 (0)