Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: This might be the one I want to turn into a project but is it 1/2 Amp? ping twystd posted by Ugly on July 20, 2017 at 18:40:16:
Is there any way to service this steel platter spindle for the wear from the bearing? It looks as if there may be a dissimilar piece pressed into the center of the shaft where the bearing wear is. The center is slightly darker in color than the surrounding metal.Would bonding a thin thrust plate to the end of the spindle work? Check out the link. They come in every diameter you could ever want.It doesn't look like it would be a problem for the idler action mechanically, but what the hell do I know?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I'm not a machinist. What do you inmates think about this? - Ugly 07/21/1720:23:58 07/21/17 (4)
- RE: I'm not a machinist. What do you inmates think about this? - dtut 10:36:50 07/28/17 (2)
- RE: I'm not a machinist. What do you inmates think about this? - Ugly 18:51:34 07/28/17 (1)
- RE: I'm not a machinist. What do you inmates think about this? - dtut 11:55:29 07/29/17 (0)
- RE: I'm not a machinist. What do you inmates think about this? - twystd 23:37:49 07/21/17 (0)