Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Vinyl Asylum ]

---

[ Alert Moderator ]

---

RE: Success! Lightweight acrylic plate for Gyro SE...

Posted by Roastaman (A) on December 5, 2014 at 23:04:04

In Reply to: Success! Lightweight acrylic plate for Gyro SE... posted by tketcham on December 4, 2014 at 19:52:13:

Hi tketcham,
You got me thinking about my Orbe and remembering some of the things I had some issues with as well. So what happened when you tried to remove this lopsided tilt by adjusting the corresponding springs to raise/lower the subchassis? Was the tilt too much to adjust for? My Orbe subchassis has more than a slight tendency to favor sagging towards the tonearm if all the towers were adjusted evenly so the height of the threaded riser's were identical. I have noticeable differences between the heights of these threaded risers when they are adjusted so the subchassis height above the chassis is made even or better yet when I use a level to set platter levelness.

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---