Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Vinyl Asylum ]

---

[ Alert Moderator ]

---

RE: Success! Lightweight acrylic plate for Gyro SE...

Posted by mondial (A) on December 5, 2014 at 13:54:29

In Reply to: RE: Success! Lightweight acrylic plate for Gyro SE... posted by tketcham on December 5, 2014 at 12:19:49:

Hi,

The weight of my Arm is similar to the SME. I have installed a Kuzma Stogi Ref tonearms to my Full GyroDec. The weight of the arm is around 800gms . The arm's mounting flat form is Linn compatible. Ordered one from Analog seduction. The arm board weigh 435gms & 18mm thick. Michell instructed me to bring it to a Machinist and shave 9 mm to achieve the ideal weight. Mounted it & no problem w/ the balance & bounce. My GyroDec is a Mark 1 upgraded to the latest specification ( spring turret, springs, conical feet, inverted bearing ,Orbe clamp w/ the Orbe Platter upgrade & Stand Alone motor mount). Still using the original robust AC Papst motor. I had this table since 1986. Currently using the original Gyro Wall wart Power supply plugged to the VPI SDS.



Mondial

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---