|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: RE: How about this for a thrust pad material? posted by Tre' on September 10, 2017 at 16:37:52:
how do I get the little ball out of the end of the shaft?
I want to change that also. I'm looking at a Ceramic Bearing Ball Si3N4 G5 as a replacement.
This is on a VPI HW-19 Mk3
Thanks.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- OK, 16.5mm will fit but now.... - Tre' 09/10/1718:58:36 09/10/17 (5)
- This is the advice I got to remove the ball - Barry 19:13:12 09/11/17 (1)
- RE: This is the advice I got to remove the ball - Tre' 20:29:51 09/11/17 (0)
- RE: OK, 16.5mm will fit but now.... - Not Yet There 10:55:48 09/11/17 (1)
- Got it, thanks - Tre' 11:06:56 09/11/17 (0)
- Should sound terrific and... - Barry 07:11:31 09/11/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
