|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Teres/ET2 Wire Armboard Hole Placement posted by Mister Pig on May 8, 2003 at 22:18:10:
I started checking everything again and like you found out the block with the air bearing was not level but when I looked carefully at the spindle from the side towards where the O rings are in the manfifold it looks like the is a little off center so I put a level on the spindle and it was level. I relocated the wire to the front with enough slack to not affect the arm, I tape it down and releveled the tonearm with Hi Fi News Test record using blank spots, when I went back to listen I found out the same as you zero surface noise and balance was dead center. This was a major improvement over what I thought was a very nice sound already, I have never heard a table/tonearm/cartridge sound this quiet on surface noise and music sound so nice, it just flows.Thank You for the help.
Steve...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Teres/ET2 Wire Armboard Hole Placement - Cougar 05/9/0307:28:01 05/9/03 (1)
- Re: Teres/ET2 Wire Armboard Hole Placement - Cougar 07:41:11 05/9/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
