|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
|
|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Teres/ET2 Wire Armboard Hole Placement posted by Cougar on May 8, 2003 at 12:01:51:
I have an ET II mounted on a Teres also. I did not drill a hole for the wire, but instead just made sure I had enough sitting on top of the armboard to allow the arm to travel fully. I haven't had any problems getting the arm to float. A couple of weeks ago I took a level to the block that the air bearing attaches to, and found it to be slightly out of level. I re leveled it, and then re adjusted the main pillar, and got the whole arm spot on. It's amazing how good it sounds. I figuired I got a 15% improvement in my overall sound by getting this arm dialed in. Another benefit was that my turntable became even quieter. Record noise is almost non-exsistant. I bought this arm 2nd hand, and for the 350 bucks I got into it, I can't think of a better arm to have.Regards
Mister Pig
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Teres/ET2 Wire Armboard Hole Placement - Mister Pig 05/8/0322:18:10 05/8/03 (2)
- Re: Teres/ET2 Wire Armboard Hole Placement - Cougar 07:28:01 05/9/03 (1)
- Re: Teres/ET2 Wire Armboard Hole Placement - Cougar 07:41:11 05/9/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
