RE: Note the 100 Hz reference.

Posted by John Elison (A) on December 18, 2009 at 21:16:17

In Reply to: Note the 100 Hz reference. posted by Daverz on December 18, 2009 at 14:31:21:

I tested an AT33PTG in my SME V a few years ago and I measured about 25 x 10 ^-6 cm/dyne compliance at the arm/cartridge resonance frequency. Check out the link below for specific details.

Best regards,
John Elison

Measuring Arm/Cartridge Resonance (Open in New Window)

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - New version of Audio-Technica OC9 - jcarr 12:07:26 12/16/09 (12)

RE: New version of Audio-Technica OC9 - John Elison 23:23:08 12/16/09 (0)

Here on eBay - krenzler 14:12:54 12/16/09 (10)

23,635 yen difference - brad s 17:53:33 12/16/09 (0)

RE: Here on eBay - EagleRocker 14:32:02 12/16/09 (8)

RE: Here on eBay - krenzler 14:50:20 12/16/09 (7)

RE: Here on eBay - EagleRocker 16:11:56 12/16/09 (6)

RE: Here on eBay - Cpk 16:32:21 12/16/09 (5)

Yup. It's a definite bargain... - tketcham 18:45:11 12/16/09 (4)

They don't like to share the good stuff with the gaijin? - Daverz 09:15:45 12/17/09 (3)

High compliance?.... - B.Zak 09:19:54 12/18/09 (1)

Note the 100 Hz reference. - Daverz 14:31:21 12/18/09 (0)

RE: Note the 100 Hz reference. - John Elison 12/18/0921:16:17 12/18/09 (0)

RE: Note the 100 Hz reference. - Bjerager 00:09:39 12/19/09 (0)

RE: They don't like to share the good stuff with the gaijin? - tketcham 12:40:44 12/17/09 (0)

Follow Ups

RE: Note the 100 Hz reference. - John Elison 12/18/0921:16:17 12/18/09 (0)

RE: Note the 100 Hz reference. - Bjerager 00:09:39 12/19/09 (0)

RE: Note the 100 Hz reference.

Post a Message!