|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Modifying power supply in solid-state amp (Bobwire?) posted by Allan Moyse on February 8, 2001 at 20:21:59:
Like I said about the Adcom 535, I would do the same to this amp. An extra set of filter just for the output transistors. Seperate the output stage from the driver stage supply. In the Adcom I added two new bridges and filter sets just for the drivers. It works good and the amp never sounded better. In the Adcom the resistors for the output devices were all over the map in value. From .1 ohm to .56 ohm. They were speced at .22 ohm! A bigger cap across the bias pot seems to help too. Let us know how it works out OK. bobwire
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Modifying power supply in solid-state amp (Bobwire?) - bobwire 02/8/0123:16:24 02/8/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]