|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Anyone used an induction heater to re-activate the getter? posted by LowRedMoon on December 21, 2020 at 08:22:52:
Most likely, as 6bq5 stated, all the raw material, that should be vaporized, is already gone from the cup. In that case you will end up heating the metal structure, which will outgas like crazy. So your net effect might be lower vacuum.
In the unlikely case that you still manage the vaporize the remaining material, the abovementioned outgassing is probably going to swamp that additional effect.
The best advice is to leave the tube alone, if its getter is still there.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Anyone used an induction heater to re-activate the getter? - Victor Khomenko 12/21/2010:56:57 12/21/20 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
