Greetings- I was looking at the Edcor push-pull outputs for a 45 push pull that I'd like to build soon. The CXPP25-1 has a 7600 ohm primary and dual 4 ohm taps. Question: Is the 7600 ohm primary high enough for 45s or should I ask for a higher one, say 10,000 ohm? Also, this dual 4 ohm secondary, would I be better off with the CXPP25-2 which has dual 8 ohm secondaries? (I'm not familiar with either setup) I was told by the gentleman that the transformers could be wound however I needed them ( within reason) so would I be better off getting just a single 8ohm (or 6 ohm) secondary? Thanks very much for your help. wpod PS- would their XSM 10K/10K interstage work correctly between a 6sn7( or 71A) and the push-pull 45s? Thanks
This post is made possible by the generous support of people like you and our sponsors:
Topic - Advice needed on Edcor push-pull outputs - wpod 10:50:51 09/29/05 (5)
- Re: Advice needed on Edcor push-pull outputs - Jim Doyle 23:20:15 09/29/05 (0)
- Listening to Edcor 10K/10k intersatges right now... - drummerwill 20:21:45 09/29/05 (2)
- Re: Listening to Edcor 10K/10k intersatges right now... - Scholl 03:37:13 09/30/05 (0)
- thats really good to hear! - Jim Doyle 23:02:02 09/29/05 (0)
- Re: Advice needed on Edcor push-pull outputs - Tom Bavis 15:47:30 09/29/05 (0)