|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: How to design a passive single-network RIAA (two tubes) posted by Chris O on March 25, 2002 at 06:38:45:
Hi Chrismy verion of SRPP z-out formula with both sections identical and top tube designated as having RK1:
Zout= 1/gm*(mu*(Rk+1/gm)/Rk1)) - hope that's correct - its easy to use dos version of ECAP to get Zout, gain etc for a tube circuit using FET model then placing plate resistance (rp) across it to emulate a triode (or pentode) - just draw a schematic then number nodes, and give values to resistors, etc
sometimes a bit more gain can be squeaked by having RIAA eq's ~1Meg grid resistor preceed caps but overload of 2nd stage might be an issue at times (?) - I'm outta practice with tubes - anyone here using lumped RIAA phono with grid resistor up front?
Freddy
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: How to design a passive single-network RIAA (two tubes) - freddyi 03/25/0210:35:48 03/25/02 (2)
- Re: How to design a passive single-network RIAA (two tubes) - Kurt Strain 10:54:54 03/25/02 (1)
- Re: How to design a passive - botched equation - White CF? - freddyi 11:41:58 03/25/02 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
