|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Power supply????????????? posted by xaudiomanx on February 22, 2018 at 07:21:17:
Better? It's hard to say with the info given. Depends on the plate load CCSs used and their voltage needs and the required room for signal voltage swing. That said, 10V extra most likely will not task the CCSs nor their heat sinks. But better?
I'm curious though. You said you are suing a shunt regulated supply with gas regulator shunt tubes. These tubes "set" the voltage. You seem to imply that you can adjust the regulated output. How's that?
"It is better to remain silent and thought a fool, then speak and remove all doubt." A. Lincoln
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Power supply????????????? - JKT 02/22/1811:50:02 02/22/18 (1)
- RE: Power supply????????????? - xaudiomanx 17:51:48 02/22/18 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
