|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: B+ PSU Hen Scratches posted by jyourison on April 28, 2013 at 08:48:21:
Mouser stock # 542-5900-152-RC is what you need. As part of the Bourns conglomerate, long time coil winder J.W. Miller is still "on the job". :> )
Either UF5408s or the 3 A./600 PIV "GI" diodes McShane uses in Cit. 2 and Cit. 5 amps are fine, for the ground side of the rectifier bridge. 3 A./600 PIV Schottky SiC diodes go on the "hot" side of the bridge. Buy 10 nF. film caps. specifically intended for snubber duty, that are rated for pulses over 1 KV., from Jim.
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: B+ PSU Hen Scratches - Eli Duttman 04/28/1309:41:50 04/28/13 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
