|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Signal path wire!!!!!!!! posted by xaudiomanx on March 22, 2011 at 12:47:08:
xaudiomanx,
Sounds like fun, hope you're doing this for the experience and fun and not expecting to have the "Why haven't I done this before" experience. ;> )
Your loading resister will be heard. Look at the amp as if the sine wave travels through it as a whole.
I'd stick to decent carbons (cheaper), NI Wirewounds or if you have money to burn ..Tants.
The metal oxide types should be tried after you have tried the above first...;> )
Have Fun
Stuben
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Signal path wire!!!!!!!! - Stuben 03/22/1116:21:45 03/22/11 (6)
- RE: Signal path wire!!!!!!!! Yes change grounds to good wire.. - Minussss3db 02:13:18 03/23/11 (0)
- And again I ask the same question!!!!!!! - xaudiomanx 16:58:48 03/22/11 (4)
- RE: And again I ask the same question!!!!!!! - SteveBrown 09:23:41 03/23/11 (0)
- Apparently, U Have All Forgotten Ground is Half the Signal !!!... - Interstage Tranny 09:22:35 03/23/11 (0)
- RE: And again I ask the same question!!!!!!! - Triode_Kingdom 20:28:11 03/22/11 (0)
- An answer is this Paul ....... - drlowmu 18:52:02 03/22/11 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]