In Reply to: RE: Half Wave Rectifier posted by timp on September 16, 2012 at 16:36:33:
TRY to "input" into PSUD2 what is really going on, to the best of your knowledge.
Insert a current tap before R2 and assign 150 mA. as its value.
Change the current tap at the end of the filter to 50 mA. OR better yet, add current taps after R2 and R3 to accurately reflect actual current draws, at different locations along the filter.
If 83 Ohms is the DCR across the entire winding, use half of that ( 42 Ohms) as a ROUGH input figure in PSUD, which will be ( not exact but ) an improvement over the 20 Ohms and 83 Ohms you have inputed.
This post is made possible by the generous support of people like you and our sponsors: