Hi, more of a machinist than a an electrical geek. I am building a new set of amps and considering carving some solid aluminum blocks to replace the stamped steel bells on the pt and opt. I was thinking to make the through fasteners studs and have some nuts on the back side. Is there any reason this would not be a good idea?
Thanks in advance for your kind attention.
Bill
This post is made possible by the generous support of people like you and our sponsors:
Topic - replacing stamped transformer bells with solid aluminum - berndt 19:08:42 04/29/12 (12)
- I did that to my Sonic Frontiers SFS-80 - david_dobson@sympatico.ca 10:46:33 04/30/12 (1)
- RE: I did that to my Sonic Frontiers SFS-80 - berndt 10:52:15 04/30/12 (0)
- RE: replacing stamped transformer bells with solid aluminum - Triode_Kingdom 20:12:00 04/29/12 (2)
- RE: replacing stamped transformer bells with solid aluminum - berndt 20:28:41 04/29/12 (1)
- "Hey it is the machinist side of DIY." - Mossback 04:07:37 04/30/12 (0)
- RE: replacing stamped transformer bells with solid aluminum - Tom Bavis 19:58:36 04/29/12 (6)
- RE: replacing stamped transformer bells with solid aluminum - Triode_Kingdom 20:14:50 04/29/12 (4)
- RE: through bolts - unclestu 12:21:52 04/30/12 (3)
- RE: through bolts - Tom Bavis 06:03:15 05/1/12 (2)
- RE: through bolts - Swanson 09:51:43 05/1/12 (1)
- RE: through bolts - berndt 10:52:22 05/1/12 (0)
- RE: replacing stamped transformer bells with solid aluminum - berndt 20:06:26 04/29/12 (0)