|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: Is there a Clean Complete ST-35 Schematic Somewhere posted by steven oda on June 21, 2003 at 12:14:36:
Good points.With the stock cathode resistor, I calculated a plate disapation that exceeded by a bit, the spec. of the EL84.
On my ST-35 i have increased the resistor to 120 Ohm. Also used a different bypass cap, same size but not the one in the three section can cap.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Is there a Clean Complete ST-35 Schematic Somewhere - Ivan303 06/21/0314:07:19 06/21/03 (2)
- Re: Is there a Clean Complete ST-35 Schematic Somewhere - pufff 09:28:55 06/23/03 (0)
- Did you try Gary Kaufman's site? - mrh (Mark Hardy) 15:28:12 06/21/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]