|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Eico HF-14 build from scratch posted by banpuku on March 25, 2015 at 06:11:13:
An exact clone is not possible without the Eico audio transformers.
The EZ81 is an excellent rectifier tube for lower wattage output amplifiers. I prefer the higher current capacity Mullard GZ34, but is expensive.
I replaced rectifier tubes in DIY amplifier designs and find better performance using low noise SS rectifiers with a low DCR design power supply.
I believe a modern 'clean sheet' design would perform best. I recommend the readily available Dynaco clone audio transformers from Triode Electronics.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Eico HF-14 build from scratch - sony6060 03/25/1507:21:01 03/25/15 (4)
- RE: Eico HF-14 build from scratch - banpuku 12:23:15 03/25/15 (2)
- RE: Eico HF-14 build from scratch - sony6060 13:24:46 03/25/15 (0)
- If you go with a 5AR4 in place of a 6CA4... - Steve O 12:54:46 03/25/15 (0)
- RE: Eico HF-14 build from scratch - banpuku 07:30:53 03/25/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
