|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: Copper, .025 inch posted by dave slagle on April 22, 2007 at 15:34:47:
Dave,That materials information is helpful to me. Thanks. Would my aforementioned and prior favorite material, 10 gauge steel be a lot better?
You see, when I did my actual listening over this past month, I was using about 10 gauge cold rolled steel, all around the power trannie, which fed into the pair of EZ81s and EL84s.
I just made the copper pieces over this weekend, and I have as yet to hear them. I will test them, and I can sub in 10 gauge steel pieces and compare the two. I had actually intened to do this, but had not taken the time to do so.
In past years, after doing some reading on the subject, I had selected the 10 gauge steel. Your Forum-posted comment will remind me NOT to delay or overlook its use again. Thanks a whole lot.
It will be easy to do it in steel, the same way as I executed the copper. Thanks !
Jeff Medwin
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Very Interesting...... - drlowmu 04/22/0718:39:32 04/22/07 (3)
- 1/4" aluminum - John Swenson 23:46:45 04/23/07 (0)
- Re: Very Interesting...... - JimL 16:06:42 04/23/07 (1)
- A combination...... - Janos 22:10:02 04/23/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
