|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: active biamp amplifier gain posted by ketchup on February 16, 2019 at 13:39:29:
Complex but if U have a sine wave signal at the crossover point, put it in the upper driver. Then reverse phase in the lower driver. Finally reverse phase in the driver that is in anti phase with the test signal. Adjust volumes so there is hopefully no sound or at least no sound. There were commercial crossovers that had this built in.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: active biamp amplifier gain - hahax@verizon.net 02/17/1920:32:45 02/17/19 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
