In Reply to: Razoring MG-I IMP posted by magiccarpetride on January 6, 2012 at 10:27:14:
I recently finished the full Razor on MMG's. Assuming the 1's are similar construction (pole piece of punched aluminium) the process stays the same.
An item of note about cutting the deadening material: instructions say use scissors. Forget that, miserable! I had great luck using a box cutter and metal carpenter's t-square as a straightedge. Any straight piece of metal should do. Place the dampening material on a sheet of scrap plywood or something, line up the metal ruler top & bottom by eye, and forcefully draw the boxcutter down the material. Repeat as needed. I got pretty good at it within 20min and did a full panel in a bit over an hour, not bad.
I used Fat Mat instead of the material in the instructions - similar material, asphalt, slightly smelly, much cheaper, shiny. Good results. Have fun!
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Razoring MG-I IMP - acroy 01/6/1210:47:00 01/6/12 (0)