|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: My IIIas are symmetric. nt posted by andyr on December 23, 2007 at 15:32:10:
I got out the flashlight and tape measure. I measured the following distances in inches from the top of the speaker to each tuning disk.
MG1.6 left: 8.25, 19.25, 28.5
MG1.6 right: 8.25, 19.25, 31.5
Only the bottom tuning disk is different. This arrangement makes a great deal of sense.
The top two disks (smaller panel area = higher resonance frequency) need to be the same on left and right otherwise the stereo imaging would drift off-center.
The bottom disk (larger panel area) probably controls resonances low enough in frequency not to affect imaging.
Ed
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- My MG1.6s are asymmetric - EdG 12/23/0716:14:29 12/23/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
