|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Ha ha posted by Jon L on March 9, 2005 at 12:29:42:
Yeah, you are right, too cheap to pass up.
91 db efficient too ... did someone say Tubes, LOL.
I will give them an honest review, and i will laugh my ass off if they kick both my Eminent Technology LFT V111a's and the MG3A's butts.
If they do, perhaps i will stack em, and use the MG3a's ribbon tweeter.
If the SRS driver can go way up to 10k, i bet it is directional as hell up there ?
that means, in one spot, it should image lime a mutther funker, huh ?
Or, they could msound like unadulterated sheeit, in which case the styrofoan drivers should make good beer coolers.
Actually, SRS had the styrofoam specially made for them, because the engineer told me that todays styrofoam is different from yesterdays. The adhesives used are the exact same ones used by PolyPlaner.
PolyPlaners were used in a Lot of Dental offices, because they were flat, and easy to install.
I "auditioned" them in a dental chair, sounded pretty good too, or was it the Nitrous Oxide, LOL !
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Maybe My Magneplanar MG3a's Can Donate Their Ribbons To The Cause ? - ka7niq 03/9/0512:55:43 03/9/05 (1)
- These SRS's sound like the BES speakers of the past - Ron L 06:52:06 03/10/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
