|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Re: Zobel values for MG1.6? posted by Mart on September 21, 2001 at 20:54:01:
Hi Mart,- Assume you meant an 8 ohm Mills resistor (the link lists 12w resistors) or an 8w 4 ohm resistor?
- The Zobel would be the Mills resistor + .47mf AudioCap Theta cap
In addition to trying this, you suggest also using the bypass cap:
- in place of the AudioCap?
- in place of the entire Zobel?
(Just want to make sure I understand correctly and don't do anything silly ie. that I will regret!)Side question: I thought that the resister value tended to typically be close to the impedance rating of the speaker, which for the maggies would be @ 4 ohms (if I my assumption for an 8 ohm resister above was correct).
Thanks... and pardon the density at the receiving end.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Some clarification needed... - s.hum 09/22/0106:05:27 09/22/01 (6)
- Re: Some clarification needed... - Mart 06:52:40 09/22/01 (5)
- Great! - s.hum 07:35:48 09/22/01 (4)
- should re-emphisize - Mart 07:50:27 09/22/01 (3)
- Network location - s.hum 08:21:12 09/22/01 (2)
- across the speaker terminals - Mart 08:36:10 09/22/01 (1)
- Driver inductance. - Arbelos 15:19:46 09/23/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
