|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
Hi All,Advance apologies for a likely redundant question (searched the archives w/o an obvious answer - to me) but what (good guess starting) values should be used to construct a Zobel filter for bi-wired MG1.6's (driven with a tube amp) in lieu of impedance curves for the system?
Should one just use one Zobel for the tweeter section, or better results if done for the bass too? Recommended supplies (brands of caps, resistors)?
Tx,
S
This post is made possible by the generous support of people like you and our sponsors:
Topic - Zobel values for MG1.6? - s.hum 20:09:20 09/21/01 (29)
- Re: Zobel values for MG1.6? - Mart 20:54:01 09/21/01 (28)
- Re: Zobel values for MG1.6? Me too Mart. - Todd R 07:02:31 09/22/01 (6)
- see below - Mart 07:08:56 09/22/01 (5)
- Thanks, Just saw it. How about the values? - Todd R 07:17:13 09/22/01 (4)
- nope, it was for bi-wiring - Mart 07:28:30 09/22/01 (3)
- Like this Mart? - Todd R 14:10:03 09/22/01 (2)
- you have to use <PRE>plot</PRE> - Mart 14:50:13 09/22/01 (1)
- Thanks a bunch - Todd R 15:04:17 09/22/01 (0)
- Re: Zobel values for MG1.6? - s.hum 06:14:36 09/22/01 (13)
- Re: Zobel values for MG1.6? - Mart 07:06:46 09/22/01 (12)
- Re: Zobel values for MG1.6? - Monk 13:16:21 10/5/01 (11)
- as initially designed yes - Mart 13:39:55 10/5/01 (10)
- Re: as initially designed yes - Monk 13:52:31 10/6/01 (9)
- to make a long story short ... - Mart 08:59:49 10/7/01 (8)
- Re: to make a long story short ... - monk1 12:23:23 10/8/01 (7)
- attenuation in RF region - Mart 22:37:19 10/8/01 (6)
- Re: attenuation in RF region - Monk1 11:01:51 10/9/01 (5)
- 1mm penetration is a 1D model - Mart 11:34:36 10/9/01 (4)
- Re: Skin depth - Monk1 14:04:04 10/9/01 (3)
- Re: Skin depth - Mart 14:55:10 10/9/01 (2)
- Re: Transmission lines - Monk1 15:42:42 10/9/01 (1)
- just substituted a long cable length - Mart 00:42:58 10/23/01 (0)
- Some clarification needed... - s.hum 06:05:27 09/22/01 (6)
- Re: Some clarification needed... - Mart 06:52:40 09/22/01 (5)
- Great! - s.hum 07:35:48 09/22/01 (4)
- should re-emphisize - Mart 07:50:27 09/22/01 (3)
- Network location - s.hum 08:21:12 09/22/01 (2)
- across the speaker terminals - Mart 08:36:10 09/22/01 (1)
- Driver inductance. - Arbelos 15:19:46 09/23/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
