MagneQuest/Peerless Forum Welcome! Need support, you got it. Or share your ideas and experiences.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ MagneQuest/Peerless Forum ] [ Return to Search Results ]

---

[ Alert Moderator ]

---

Triodes for damping factor, Nickel cored OPT for detail

Posted by Jim Doyle (A) on October 23, 2006 at 13:07:47

In Reply to: Re: Triodes for damping factor, Nickel cored OPT for detail posted by Inkasound on October 23, 2006 at 12:20:04:

You can get them here.... I have one channel complete of an Amity
using an MQ 565/Ni as output. I'm using 6AV5's at the moment. Strapped as triodes, they look like 2A3s.

You could use any of the Peerless (5K, 6.6K load) to do the same and
you could ask for either a full nickel core or a pinstripped core, depending on your real (versus perceived) power needs.

My Amity Clone is very much a mix-n-match of vendors. MQ 565 output.
Lundahl 1660S PP interstage. Sowter 3575 input / phase splitter tranny. Triode Electronics ST-35 dynaclone PSU tranny. :)

This fully PP amp has a very unique and special sound.. The SETH
would be cheaper to build though.

-- Jim

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---