|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
|
|
High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place. |
|
In Reply to: Question about audio generator posted by Joe Gibney on September 5, 2001 at 15:19:07:
Joe -with an addtional 600-1K in series and a switchable 10 ohm shunt calibration resistor you should be able to measure Z OK without a power amp - 10 ohm 1% resistor would be kicked in at each test point and generator's output set to read "10" on some scale of your DVM or VTVM - then kick that resistor out to read the Z - Speaker Workshop is a jillion times faster! (and free 'cept for building a test jig, mike preamp, etc - all pretty cheap stuff - also -pretty graphs!):
http://www.gti.net/wallin/audio/jig2/jig2.html
Freddy
ps - with efficient speskers you may hear it - my HP 200CD has a lotta drive
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Question about audio generator - freddy 09/5/0117:46:17 09/5/01 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
