|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Dynaco-Doctor Forum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: Re: Where does the negative wire go from pin to driver board posted by Russ57 on June 10, 2006 at 20:24:11:
The original dynaco diagram shows the RCA inputs grounded to two unmarked eylets just above 9 and 10 I think.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? - Marshall W 06/10/0621:23:44 06/10/06 (2)
- Re: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? - Carl B. 05:31:38 06/11/06 (1)
- Re: 10 and 8 go to the preamp sockets via the 10 ohm resistors, don't they? - Russ57 07:08:40 06/11/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
