In Reply to: RE: Attn: Duster posted by The Dill on December 18, 2019 at 06:05:09:
I have finished the re-termination project and it turned out great. I was able to twist the wire ends and then bend them to make a thicker mass to insert in the lug. The end result was too thick to fit inside the lug, so used my Dremel tool with a sanding drum bit and was able to reduce the mass to fit inside (photo taken before the Dremel tool). That actually worked very well. Crimping the lug, wrapping Teflon tape near the entrance to the lug and up the wire a bit and some shrink wrap and it was done. These lugs are excellent, well made at a very reasonable price. Furez SP8-W38NP. Thanks again Duster for your help.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Attn: Duster - The Dill 12/25/1906:33:41 12/25/19 (0)