In Reply to: Re: HELP! C4S for SEX amp, Got questions posted by fc_harry on May 2, 2005 at 19:39:51:
Are you trying to figure out where the C4S go?
Or:
If your trying to figure out R1 and R2 values, then you did the same thing I did when I read the instructions. I put way too much thought into it and spent hours figuring it out.
-------------------
Both actually.
I think that the board is supposed to replace the 220 ohm resistor that's on pin 4, is that right?You did this on your SEX amp, right?
That chart made no sense at all to me, so if those are the correct values I'll go with that. Build it as a current source version and not the current sink, right?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: HELP! C4S for SEX amp, Got questions - Todd R 05/2/0520:04:22 05/2/05 (2)
- Re: HELP! C4S for SEX amp, Got questions - fc_harry 20:25:18 05/2/05 (1)
- Re: Yes, current source or plate load (nt) - fc_harry 20:37:59 05/2/05 (0)