In Reply to: Suggestion for Doc posted by JFT on December 25, 2004 at 14:45:22:
I'm not a first timer, this is about my 4th kit and second Bottlehead kit (did the Seduction and the CS4 upgrade prior to this).I actually did do the kit correctly, I just assumed I did something wrong because the output was so low with the load resistors in place.
The instructions were excellent, I only had trouble in 2 places
(Doc, you may want to do a small revision).Typo Page 21, last step. It says "attach red wire to top hole of terminal 19." It should be terminal 39, not 19.
I was also a little confused when it came time to wire the plate chokes (pg. 23) when it referred to terminals 1 & 4. Which ones were they? The choke was already screwed down at that point and the terminal numbering couldn't be seen without removing them from the mount.
It might be a good idea to write which one is which on the mounting plate like you do when you mark all the other terminals.Those 2 items, and noting that the load resistors on the binding posts were optional, would be the only things I would change. Other than that the kit is just fine.
Sounds killer BTW!
Todd R
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Suggestion for Doc - Todd R 12/25/0416:09:57 12/25/04 (0)