|
ANK AudioKits Forum ANK AudioKits support forum |
|
|
|
ANK AudioKits Forum ANK AudioKits support forum |
|
In Reply to: RE: How to convert OTO Phonoe SE into preamp. posted by Frank E on September 30, 2009 at 16:04:38:
is to find out from Audio Note if it's OK to run your Oto without a load on the speaker terminals. A lot of tube amps need some loading to prevent the possiblity of overvoltages on power section components.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- One very important thing . . . - Frank E 09/30/0916:18:48 09/30/09 (8)
- RE: One very important thing . . . - RGA 00:13:28 10/1/09 (7)
- RE: One very important thing . . . - Frank E 13:32:34 10/1/09 (6)
- RE: One very important thing . . . - RGA 14:23:13 10/4/09 (0)
- RE: One very important thing . . . - R Browne 09:29:21 10/3/09 (1)
- "M1 pre" - Frank E 10:25:41 10/3/09 (0)
- I use the loop for headphone amps - Frihed89 17:37:56 10/2/09 (2)
- Does the OTO have a tape or monitor out? - Frihed89 03:06:58 11/18/09 (0)
- RE: I use the loop for headphone amps - RGA 14:08:49 10/4/09 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
