|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Cary SLI-80 Int Amp problem. Update: solved! posted by airtime on December 11, 2021 at 19:00:29:
On the E-H tubes that are in now the tubes are well above the screws. The screw cutouts only line up over the one screw on the Cary top plate near each of the two LC tubes. The RC tubes cutouts don't even line up but all are unneeded for the E-H KT88s. I'll need to check the Gold Lion tubes after shutdown.
The center alignment "tabs" line up correctly with the "slot" in the tube socket. In my previous post I'm referring to the center plastic pin from which the alignment tab protrudes. That pin may be too long and hits something, therefore allowing the tube to be loose (i.e., it can rock) in the socket. The Gold Lion KT88 tubes don't fully bottom out in the tube sockets.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Cary SLI-80 Int Amp problem. Update: solved! - Terry P 12/11/2119:31:00 12/11/21 (4)
- RE: Cary SLI-80 Int Amp problem. Update: solved! - uncle mag 16:27:31 12/14/21 (3)
- RE: Cary SLI-80 Int Amp problem. Update: solved - Terry P 17:41:43 12/14/21 (2)
- RE: Cary SLI-80 Int Amp problem. Update: solved - uncle mag 01:36:13 12/15/21 (1)
- RE: Cary SLI-80 Int Amp problem. Update: solved - Terry P 15:01:53 12/15/21 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]