Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: how to separate output transistors from heat sink? posted by Ying L on May 16, 2021 at 10:07:31:
Sometimes it is suction, try sliding the transistors slightly, that usually helps.
Just curious why are you doing this, are you swapping out the board? Usually your best bet to finding an intermittent problem is with it assembled and on. Intermitents are temperature or vibration, and sometimes with thermal expansion, there is very little difference. Touching with a non conductive tool or cold spray are good ways of locating the cause of the problem.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: how to separate output transistors from heat sink? - fredtr 05/16/2118:01:24 05/16/21 (0)