|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: As bare noted, they are wired for Bi-Wiring, which is mostly a joke ............. posted by LtMandella on February 13, 2021 at 17:32:12:
Yes, however, each amp would not be as efficient using the bi-wire connection as the internal crossover is wasting the spectrum that it is blocking from the signal. Active biwiring is better because the amp only sees the spectrum that is needs to drive the portion that it is driving.
Another issue is the difference in gain. Unless the two amps are identical or have the same gain, one will be louder than the other, e.g. two much tweeter or too much bass. An active crossover would allow you to both set crossovers as well as gain.
-Rod
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: As bare noted, they are wired for Bi-Wiring, which is mostly a joke ............. - Rod M 02/13/2118:07:37 02/13/21 (3)
- "Wasting the spectrum" - Craiger56 07:22:48 02/14/21 (1)
- RE: "Wasting the spectrum" - Rod M 17:48:09 02/14/21 (0)
- RE: As bare noted, they are wired for Bi-Wiring, which is mostly a joke ............. - pictureguy 18:21:10 02/13/21 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
