|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Sounds like posted by jmac7 on June 7, 2016 at 12:25:15:
If the low volume channel is putting out a single-ended signal instead of balanced, it will be 6db below (much less volume) the good, balanced channel.
An easy, non-technical way to check: connect the low volume balanced channel output to a balanced input, and the other channel from the single-ended output to a single-ended input. If they play at the same volume level, then you have found what the problem is: the "balanced" signal is playing single-ended. Detecting where the problem is will be a bit more difficult.
You will need to swap balanced/single-ended connections for both inputs and outputs and use logic to determine which unit is at fault. I bet it's the modded component, and I bet the fix is easy for any technician.
Peace,
Tom E
berate is 8 and benign is 9
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Easy way to check - madisonears 06/7/1618:26:15 06/7/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
