|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: MIchael Yee Audio posted by Vic D on October 10, 2013 at 09:34:16:
Buzzwords galore in the topology description:
"The PA-3 has a “Current” output rather than a “Voltage” output. This causes the amplifier to “interact” a bit with the load, giving a bit of a supple sound. The output stage uses MOSFETs in a current output configuration rather than the typical voltage follower configuration (source follower). MOSFETs have often been associated with a “soft” or “hazy” sound. The “supple” sound I refer to is not like this at all, it is a much more “organic” sound."
Output impedance spec is 0.5 Ohms. Does that make it a current source?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: MIchael Yee Audio - manerac 10/11/1314:15:26 10/11/13 (3)
- I would agree with unclestu - Vic D 04:16:36 10/12/13 (0)
- RE: MIchael Yee Audio - unclestu 15:34:44 10/11/13 (1)
- RE: MIchael Yee Audio - Bill the K 08:02:41 10/15/13 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
