|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: Do you know all amps have a sweet point posted by AbeCollins on May 8, 2025 at 11:02:32:
-to run a 45 based SET amplifier! I'm sure you know that.
SETs only have about 20-25% usable power. If you push them too hard they get flabby in the bass... They really shouldn't be exposed to bass since the inductance in the output transformer is usually too low due to the cut core. That causes the load impedance to go down quite a lot; bad load for a power tube.
A properly fixed up Dynaco ST35 (their best sounding amp) would be a much better choice for the Tannoys.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- You need 105dB sensitivity or so - Ralph 05/8/2512:19:51 05/8/25 (6)
- Ralph, you can say that again! - Tre' 15:03:45 05/8/25 (1)
- No need- you said it better than I did :) nt - Ralph 08:32:47 05/9/25 (0)
- RE: You need 105dB sensitivity or so - mg16 13:21:22 05/8/25 (1)
- RE: You need 105dB sensitivity or so - Tre' 15:39:26 05/8/25 (0)
- RE: You need 105dB sensitivity or so - Leo loves music 12:27:18 05/8/25 (1)
- An 805 based amp is not a 45 based amp. - Ralph 13:02:09 05/8/25 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
