RE: Rek O Kut dilemma

Posted by philltubes (A) on June 21, 2010 at 18:56:13

In Reply to: Rek O Kut dilemma posted by wolfy on June 21, 2010 at 18:40:56:

Wolfy, just a wag here but have you had the idler wheel rebuilt, it seems to me that a worn wheel would turn the platter faster than a properly sized wheel which could then be adjusted to the correct speed?

This post is made possible by the generous support of people like you and our sponsors:

Follow Ups Full Thread

Topic - Rek O Kut dilemma - wolfy 18:40:56 06/21/10 (16)

RE: Rek O Kut dilemma - hifipaul 18:45:37 06/22/10 (0)

These were built when 115 v was common. - tubesforever 23:26:07 06/21/10 (2)

How about a small Variac ? (nt) - Interstage Tranny 14:42:47 06/22/10 (1)

Sure it will work. - tubesforever 01:56:41 06/23/10 (0)

Speed control VFD - JoMoCo 20:57:18 06/21/10 (0)

A small electric motor not connected to anything as another load on drive motor - Elizabeth 19:23:32 06/21/10 (0)

RE: Rek O Kut dilemma - coffee-phil 19:01:07 06/21/10 (0)

RE: Rek O Kut dilemma - manfred88 18:59:49 06/21/10 (1)

RE: Rek O Kut dilemma - wolfy 19:09:39 06/21/10 (0)

RE: Rek O Kut dilemma - philltubes 06/21/1018:56:13 06/21/10 (0)

Increase the diameter of the platter with a sleeve - Elizabeth 18:52:33 06/21/10 (1)

Not sure if I follow you. - tubesforever 13:34:28 06/22/10 (0)

RE: Rek O Kut dilemma... how much too fast? - Bigromano 18:48:15 06/21/10 (3)

RE: Rek O Kut dilemma... how much too fast? - fishy 18:50:35 06/21/10 (2)

RE: Rek O Kut dilemma... how much too fast? - wolfy 19:12:57 06/21/10 (1)

RE: Rek O Kut dilemma... how much too fast? - chinacat 07:09:43 06/22/10 (0)

Follow Ups

RE: Rek O Kut dilemma - philltubes 06/21/1018:56:13 06/21/10 (0)

RE: Rek O Kut dilemma

Post a Message!