Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
|
In Reply to: Re: Akito 1 with high vertical resonance posted by Apokalypse on April 4, 2005 at 22:58:23:
With a high compliance cartridge and a medium mass arm, I would expect resonant frequence to be low, not high. Adding mass to the headshell is easy and should drop the resonant frequency but should not be necessary with your combination.
- Are you running with the brush up or down?
- If it is down, does it move freely?
- Is movement of the arm completely free, or are the bearings binding a little?
- Does the stylus cantilever deflect easily, or is it stiff?
- Do you have any other cartridge you can install a a cross check?
David
(No, I am not writing at 4AM, I am visiting Aus)
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Akito 1 with high vertical resonance - energyandair 04/5/0503:02:03 04/5/05 (1)
- Re: Akito 1 with high vertical resonance - Apokalypse 06:16:40 04/5/05 (0)