|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
|
|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
In Reply to: Will Mac MX-110 work with long ICs to solid state amp? posted by Chet on April 5, 2004 at 23:20:08:
The MX 110 has the balance and volume control behind the line stage. So when you listen to low volume music, the pre is driving your power amp thru up to 40 Kohm of resistor in the colume control ( assuming that the balance pot is a more modern type which has no resistant when set at the middle, but I am not sure and eprhaps depend on the version of MX 110.
Assuming if your cable has a capacitance of 25pf per foot, then for 30 ft, the capacitance will be 750 pf, and equal to 21 K ohm at 10 kc/s, which is lower then the vomune pot typical resistance at low level. That will sognificantly cut off your high freq.
Perhaps, It's better off if you get a SS line stage with an output impedence in the region of less then 1 K ohm...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Will Mac MX-110 work with long ICs to solid state amp? - wlee 04/6/0406:44:48 04/6/04 (6)
- Re: WLee, great post! - Bold Eagle 12:46:54 04/6/04 (5)
- Re: WLee, great post! - Ron-C 12:23:34 04/7/04 (0)
- will try some more mods on this MX 110 - wlee 22:43:09 04/6/04 (0)
- Finding the same thing, guys - doodlebug 15:29:51 04/6/04 (2)
- Re: Finding the same thing, guys - Bold Eagle 15:41:22 04/6/04 (1)
- Re: Finding the same thing, guys - Mac D 20:48:11 04/6/04 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
