Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Need help to connect my noble pot ! posted by KANADDICT on January 25, 2005 at 16:09:15:
IF I recall correctly, looking at the pot from the front, the left terminal is for a loudness control, forget it.Again looking from the front, the second tab is IN and the fourth tab is Ground. The third one is the wiper OUT. One row of tabs is for the left channel, the other for the right channel.
I hope this helps (And I hope my memory is good)
To be sure, your DMM should read the pot's full resistance from 2 to 4 and a variable value from 2 to 3.
Turn the pot axle fully clockwise. The two tabs that read zero ohms between them are wiper and IN.
Turn fully counter-clockwise, you will find close to zero ohms between wiper and GND. Should be easy to figure it out, as long as you ignore the extra tab.
good luck
Carlos
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Try this - Carlos 01/28/0519:20:50 01/28/05 (0)