Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Re: Two and a half Inductor Questions

Actually a minor point to add -

Transformers will vary the output voltage between no load and full load. Although better transformers are pretty well regulated, others are pretty poor. For example, there are tons of 2.5v/10a transformers on the surplus market intended for pairs of large rectifiers (866A etc). Try and use them on a 45 and you'll be well over 3v output - and shorten tube life.

Hammond is good about spec'ing their stuff with this in mind. If you look at the specs for the 166Q2 which is a 2.5v/6a model, it's rated at 3.03v NL, and 2.5v FL.

If you use an "overrated" transformer, measure the final filament in the circuit, and consider a small dropping resistor to bring the output back into line.




This post is made possible by the generous support of people like you and our sponsors:
  VH Audio  


Follow Ups Full Thread
Follow Ups
  • Re: Two and a half Inductor Questions - Gary Kaufman 02/9/0315:59:06 02/9/03 (0)


You can not post to an archived thread.