Home Digital Drive

Upsamplers, DACs, jitter, shakes and analogue withdrawals, this is it.

RE: Cat 7

You would have to run tests to see why the wired network didn't work. For example, was there any connectivity at all? Did the link lights illuminate when you plugged in the wire? What color (speed) did they show the connection operating at? Did you try ping tests to see lost packets? Did you look at Ethernet counts? All of these would help you diagnose the problem, assuming that you understood enough to know what I am talking about. Also, you could try different equipment on opposite ends of the cable. (If you don't understand what I am talking about here, then I suggest finding a friend who does and asking him to help you.)

It is certainly possible that your old wiring was not proper Ethernet cable, i.e. ordinary telephone cable. It's also possible that the equipment was somehow defective. That could be verified by moving the equipment into the same room and trying different cables. I have a lot of old hubs stored in drawers and old cables. I keep these to swap about in case I ever have a problem that is difficult to diagnose. But I really haven't, except with my Raspberry Pi where sometimes the RJ45 connector doesn't seat firmly and this confused me a few times until I learned to check it carefully.



Tony Lauck

"Diversity is the law of nature; no two entities in this universe are uniform." - P.R. Sarkar


This post is made possible by the generous support of people like you and our sponsors:
  Amplified Parts  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.