Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: Audio Note Oto SE Bi-wire not possible?? posted by zuheyr on December 3, 2004 at 00:47:54:
For bi-wiring you only need separate posts on the speaker. Separate posts on the amp are nice but not necessary. All that is needed is to connect connect separate wires from the two posts on the speaker to the corresponding single post on the amplifier. So the two reds on the speaker connect to the single red on the amp and the two blacks on the speaker connect to the single black on the amp. Ditto for the other channel.Two wires can be connected to a single post in a number of ways:
They can be connected together (solder or screw clamp) and then fastened as a common wire, banana plug or spade clip.
They can be fastened separately as wires, spade clips or stacking banana plugs
They can be fastened separately as an unmatching pair eg bare wire plus banana plug.Regards
David
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Audio Note Oto SE Bi-wire not possible?? - energyandair 12/4/0408:37:00 12/4/04 (0)