Home Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Dedicated Audio Line RFI

Your advice sounds good to me but I would also consider using twisted wire to cut down the susceptibility to RFI.

12/3 wire is twisted, readily available and inexpensive so I would probably use that. I would use a separate run for each circuit and use two wires in each for the neutral rather than sharing a common neutral in a single run. Using two wires for the neutral should minimize the voltage difference between neutral and ground under heavy load.

I have not tried this yet but I can't see how it could hurt and might help. Do you have any thoughts on it?

regards

David




This post is made possible by the generous support of people like you and our sponsors:
  Schiit Audio  


Follow Ups Full Thread
Follow Ups
  • Dedicated Audio Line RFI - energyandair 04/4/0413:59:16 04/4/04 (0)


You can not post to an archived thread.